Hello Will an Ethernet Frame always have a Src and Dst MAC address of the destination computers network card. Travel of a frame on a switch.Ethernet frame = [ "IP Packet " : Src:MAC : A Dst:MAC_B ]
On a Cisco switch, after a broadcast has taken place and a computer connected to the switch has accepted the frame even though it doesn't have a destination MAC for this computer that has accepted.Question :Why did this computer accept this frame and...
PC1 “192.168.10.5” and PC2 “192.168.10.8” are on the same switches LAN, there is no router connected to the switch, and both computers are Windows 10. There are ten computers in total connected to the switch. Problem.PC1 sends a message to PC2 and th...
HUBI have 5 Windows 7 computers all connected to an eight port HUB. PC1 wants to send a message to PC3; The person on PC1 pings the ip address of PC3. The first time, the message is sent to all "broadcast " computers connected to the HUB, then PC...
Computer 1 ( TCP / IP ) “ 192.168.10.5 “ on the switch sends a “data” message to Computer 2 ( TCP/ IP ) “ 192.168.10.8” and there is no router. This is a 20 port switch with 10 computers connected and all belong to VLAN2. It’s my confused understandi...
In the process of my research, there have been examples where it was said that in the frame - the destination mac is not known.- This of course can be a mistake on the person or person who posted this information. This is also very bad information on...
Why should a destination pc accept an ethernet frame, even if there is no destination mac address in the Ethernet frame. ??- The Ethernet frame has to be verified by destination computers to specific its network card.Example : and answer.This is broa...
Hello Joseph Sorry your answer is not in contrast to what I am asking. After a switch has a flooding, then broadcast of the one frame, - Only one PC will accept the frame with-out the destination MAC address. Why does this PC accept this Frame. ??? ...
Hi Flavio Miranda and MHM, I think you are misunderstandingThis is switch not a HUB, that has a MAC address table and the reason why there is a broadcast is because there is no destination mac address in the frame, so there will not be a destination ...
