Hello,
I am setting up a Cisco CME 10.5 as a conference bridge for SIP Phones.
The CME is already serving SCCP phones and the DSPs have been configured to provide hardware resources for conference calls and transcoding.
I am now configuring the SIP t...
Hello,
I am setting up a Cisco CME 10.5 as a conference bridge for SIP Phones.
The CME is already serving SCCP phones and the DSPs have been configured to provide hardware resources for conference calls and transcoding.
I am now configuring the SIP t...
Hello,
I am receiving a logging message from a switch of this type:
(SW_3750_1)%CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet5/1 (not half duplex), with SEP111122223333 Port1 (half duplex). (SW_3750_2)
While I receognize this as...
Why is my form page in French even though I selected English ?
I might be missing something but one would assume having to select the language once would be enough? Is this normal (acceptable) for a Cisco Portal?
Thanks,
Francesco
Dear all,
whithin CM 10.5, what is the best way to track what event (or device) is causing this alarm on RTMT:
"MediaListExhausted"
I would rather undertand the cause of the problem, before changing the threshold as adviced in the following docum...
Problem might be explained from this thread, where it seems that SIP Hardware Conference is not implemented on CME:
source: https://supportforums.cisco.com/discussion/11205391/cme-sip-hardware-conference
... Second, I'm not sure if multi-party hardwa...
Resolved the Forbidden problem by adjusting the dial-peer codecs I now have new error message:
"501: Not Implemented"
This is more interesting as it showes that the SIP Conference Bridge is not published using the same DN as the SCCP Conference Bri...
Thanks Jaime,
I need to specify an external Conference Bridge to be used by an SPA112.
I undertand SPA is an SMB device, however, this case is concerning the CME 10.5 device being used as an external Conference Bridge.
On the SPA I have the chance to...
Hi,
I cant copy and paste the output because it is on a separate machine with no internet access.
There are several phones connected to the switch. All of these switches have the following flags active:
P (Phone), H for Host and M for 2 mac relay fe...