I have another similar post in the IP Telephony forum and thought I would post here as well.I have two call managers and one Unity box. All 3 lost power. Rebooted all and now Unity does not answer when a user hits the message button. This call does n...
I have a phone that can't get to voicemail. When hitting the message button, it rings to the correct extension but never gets to the voicemail box. It just rings and rings..Any suggestions? I'm from Avaya land and just learning the good cisco stuff.
I checked Voice Mail ports in CM1 (pub) and they are now listed as non-registered but have the ip of unity. Resetting the ports does not change them from non-registered.Previously, they along with the phones, were all registered to CM2.Not sure what ...
Thanks.If I call from a non cisco phone, but in the same dial plan, it only rings 3 times on the cisco phone but I keep hearing rings. It will just ring and ring. I only let it go about 10 rings before hanging up.Should I try to let it ring longer or...
Thanks.The CM ports are setup and registered to the active CM, this being CM2.Everything was working fine before the power loss, can you think of anything else?