I already have a site to site vpn set up with a branch office, and all of the traffic that is defined in the ACL traverses the tunnel. My question has to do with Internet related traffic. Is there a way that I can define all internet traffic to go th...
Not sure if I should post this here, but I just wanted to verify that I am correct in the assumption that you can use VACL's on a Catalyst 6500 switch (PFC needed; MSFC not needed), but not on a 3750 Series Switch, correct? If I am wrong, please let...
All,I wanted to know whether there is a way to disable a NDG? I know you can delete them, but I want to disable some for testing purposes.Thanks,Matt A.
Everyone,I have a PIX 501, and I am trying to configure it as a PPPoE Client. I used the following configuration:ip address outside pppoe setrouteip address inside 192.168.2.1 255.255.255.0vpdn group PPPoE_Test request dialout pppoevpdn group PPPoE_T...
Do you have any radius accounting logs, or have you ran any debugs from the device the user is connecting to? Is the user account part of a different Radius group than other users? Any further information you can post to the forum may help greatly.
Just like the other reply mentioned, "ca save all" will save the RSA Key information, a "write memory" will not. Upon reboot, if this command wasn't specified, you will be unable to gain access with SSH. Also, if you change the domain name/host name ...
What about setting an option so that a specific user is not required to change their password, but all other users are, by inheriting the settings of the group? Is there an overide option available?
Incremental Upgrades... Look at the following link for more information in regards to backing it up and proceeding from there. http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_user_guide_chapter09186a008007deb9.htmlTake a Backup of the ...
