Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running cucm 12.5 and I have 1 publisher and 5 subscribers. One of these subscribers is at a remote site known for WAN issues. When that subscriber loses its connection to the publisher, all phones are still registered to the subscriber bu...
We use Vocera as a nurse call system and when the press a button on their keypad the button is programmed to play a certain ringtone.raw file on certain telephones. This is working fine but was implemented by people that are no longer are available...
We want to block jabber from outside the corp network (MRA) but we want to allow webex from outside the corp network. Per tacs instructions I have unchecked the "Enable Mobile and Remote Access" from the user profile. But this also stopped webex ca...
Looks like the server group has one of the ip addresses wrong for the three CPE CMs would that cause this issue? So changing it should fix it? As for the URI they are all correct.
Below are my configured dial peers on this Cube. This Cube is using PRI's from the carrier and I also noticed that the voice class server group does not have the subscriber ip address in it.dial-peer voice 1 potsdescription Incoming from PSTNincomi...
Not sure I understand your question. We have route groups to the trunk going to the cubes that are located at the same site as the questionable subscriber.
The trunk is set to run on all active. Maybe I'm incorrect and I probably am, but I thought if the subscriber lose connection to the publisher than it has no access to any of the trunks. How can I direct the outbound traffic from the subscriber th...
