Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hy AllI have Cisco Catalist 2960-x-TS-L switch.He upgraded to the latest IOS (15.2-7E11)But when I try to configure anyone of the Gigabit port I'm getting an syntax error:int GigabitEthernet 1/0/1 ^% Invalid input detected at '^' marker.Any advi...
Hy AllI have a Nexus 3548x that is configured to work as an L3 switch.I'm trying connecting him (trunk & access) to my FortiGate using sfp.In all my tries im getting:Eth1/1 1 eth trunk down Link not connected 10G(D) --Eth1/2 1 eth access down Link no...
Hy AllIn my network, there is MGMT vlan with DHCP to all devices that have MGMT interface requiring DHCP address allocation.How i can (if passable) set the mgmt0 interface to DHCP and not static IP?TnxTal
Hy AllI need to erase all current configurations from the new switches.There is no factory reset command.how can erase the running-config / startup-config?Tnx Tal
The vlans are in the db:VLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Eth1/6, Eth1/7, Eth1/8, Eth1/9Eth1/10, Eth1/11, Eth1/12Eth1/13, Eth1/14, Eth1/15Eth1/17, Eth1/18, Eth1/19Eth...
Hy & tnx for the replyi tried that but it didn't work.Interface 1/1 is the trunk to HP switch that is working.version 6.0(2)A8(11b)interface Ethernet1/1switchport mode trunkno shutdowninterface Ethernet1/2switchport mode trunkswitchport trunk allowed...
