About alanhong

alanhong · 12-07-2014

Hi , Is it possible to block only few ip phones from doing call forward all on CCME.While Allow other ip phones to Do so.we are using 79XX ip phone. 2851 CME (4.1).Please Help and share example configuration. thanksA

alanhong · 11-29-2014

Hi Friends, We have a strange issue in our Ip telephony network.all users in a call face 3-4 seconds of Audio Loss.even between extention to extention.No config have changed ,Switch interface and Voice router (2851) CME.7.0 with phone loads 8-4-2SAll...

alanhong · 06-02-2014

Hi guys,we have call block enabled on our ccme 4.2 for 900 pattern and all users use pin tomake international calls.Now we want to block all 9.T pattern after office hours for operator phones only .please advise

alanhong · 08-20-2012

Hi Guys,i have a scenario were we are moving office into a single building so during intermediate setupi will have 3 CCME s catering 3 offices who will be sharing 2 PRI lines which will terminate on a new Voice gateway. we have applied for the lines ...

alanhong · 08-20-2012

Hi Guysi have a scenario were Default STP is running in the switching Enviroment.My Scenrio is as followsi have a MDF with one Core Sw 4510 .and 10 IDF s with 2 3560 each.Having fiber connection from each switch to the core and uplink between the swi...

alanhong · 12-02-2014

Hi Aaron, 3 -4 seconds of Audio Loss at all Points its happens random ,At start ,in middle and at end.Itlooked like congestion but internal extention with on same switch to another internal extention alsohave same issue ,Debug Voice ccapi inout and D...

alanhong · 06-03-2014

Hi Nadeem, the issue is i have a call block pattern 900 for inlt calls 24*7 if i put "after hours expempt"i cannot control users for international calls with pin all of them will overide the functionplease share your thought

alanhong · 06-02-2014

Thanks Nadeem for your reply but the issue is i want to block outgoing callsafter office only for reception phone. other phones should work normalwe are blocking 24/7 international call using call blocking,users use login pinso if i put other pattern...

alanhong · 08-21-2012

two Edge switch in IDF , uplinked to each other and one up link each from these switches to the Core switch.iwhat i want to achive is the link between egde switch to be in block state and only if one up link to core sw breaksthe uplink between switc...

alanhong · 08-20-2012

thanks for the quick response .i will post again after i try it out !!! just want to make sure supplementary services like transfer and conference will not be affetedthanks

Member Since	‎09-12-2004 08:28 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	36

User Statistics

User Activity

Disable or Block Call Forward ALL on Few ip phones

Internal and External calls Loss of Audio on all ip phones

Outgoing Call block on operator 7961 after office-hours

3 CCME and 2 PRI lines on 1 Voice Gateway

STP Tuning

Hi Aaron, 3 -4 seconds of

Hi Nadeem, the issue is i

Thanks Nadeem for your reply

STP Tuning

3 CCME and 2 PRI lines on 1 Voice Gateway