Hi,I have tried to install MPLS VPNV6 between different MPLS PE I can see the routes inside the VRF and also the next-hope is reachable but I can’t ping between  two VRFs  in two different PEsPE1# ping vrf ABC ipv6  2002:172:9::10 source  2002:172:9:...

Hi,I have configured VPLS bgp signaling between ASR & Junos the VPLS  connection from Junos side indicate it’s up without any problem but from ASR side it’s down The following output form Junos & ASRRP/0/RSP0/CPU0:IGW-LON-1#show l2vpn bridge-domain b...

Dear ,I’m trying to configure INTER-AS VPLS as the attached topology the ASBR1:Cisco IOS , PE1:ASR9K and ASBR2:Juniper MXThe L2vpn BGP Multi-hope BGP is up and I can see the label swapping form the both end but the VC is down RP/0/RSP0/CPU0:IGW-LON-1...

Dear ,do you have any idea how to run BGP as PE-CE routing protocol over PPPOE Thanks

Dears,Is possible to run a TDM service over two STM-1 channelized by pseudowire circuit , what about the encapsulation Thanks