I have set up fax to email on my UC560, though recently switched vendors for our telephony service.  I thought it was going to be a straigh pri-pri switch, but it was not.  I'm being asked to set my system to receive at 9600bps.  Is there a way to do...

I've got a question here that I don't know the answer to off hand.I've got a remote site that is a small office.  There are no servers(Active Directory) at that site, though there is a local file store.  The site has a l2l tunnel back to HQ, where th...

Short story, for a remote access VPN, i'm trying to auth against an ldap server on the outside of my branch office.  The branch office has an ASA 5505 sec plus.  The LDAAP server is in a data center behind a 5520, though it is statically nated to an ...

So, I'm fairly new to all of this.  But I'm looking to introduce an outside internet connection to each of our sites.  What I would like to do, is set up site to site VPNs as standard communications, and have our MPLS backbone be a failover route. Wh...

I have a simple network pictured above.  The Firewalls are ASA5505's.I have it setup just like the picture.  THe left ASA has an ISP and is the default gateway of the 10.10.4.0 net.  The right ASA is the default gatewy for the 172.16.7.0 net, and has...