Thomas Vådahl
Level 1
Level 1
Member since ‎04-10-2002

User Statistics

  • 19 Posts
  • 0 Solutions
  • 2 Helpful votes Given
  • 5 Helpful votes Received

User Activity

I know this question has been asked before, but I need to know the temperature thresholds of the ASR9010 platform in a table format. I would really like to see a table in the same format as presented for the ASR9001 (
Hi,We have several ME-3400 switches in our network. Recently a couple of them have made interfaces go into errordisable mode for reasons we don't quite understand. This happens when the equipment connected to the interface is restarted. Here is the l...
We have a lot of 3550 switches in our network. On the FastEthernet ports we have configured broadcast control like this:storm-control broadcast level 2.00In my opinion this should limit all broadcast traffic to 2% of the interface speed, which is 100...
We have several 4500 switches with Supervisor Engine V. It says in the specification that the operational temperature is between 0 and 40 degrees celcius.What happens if the temperature rises over these thresholds? Will the supervisor shut itself dow...
We have a 2600-series router with a 4-port BRI module, and we have several dialers configured. These dialers are all going to dial a bank (the exact same bank, and exact same number), but they are triggered by different IP-addresses. To do this with ...
Community Statistics
Member Since ‎04-10-2002 01:39 AM
Date Last Visited ‎04-19-2018 01:47 PM
Posts 19
Total Helpful Votes Received 5
Helpful Votes From
Helpful Votes Given To