hi,I was trying to configure MPLS VPNs on Cat 3550, but I experienced some problems. When I create 2 or more VRF, I get too many packet losses on those VRFs. So without any VRF it works fine, when I add a VRF it again works as it is supposed to work....
hi,I tried to encapsulate a subinterface on a Layer 3 interface ( no switchport ) on Catalyst 3550 but there was no option for encapsulation dot1q <vlan number> command?When I try to add a IP address on that subinterface it notifies me that :Configur...
Is there any problem to use bgp private AS when multihoming to different ISPs and advertising the IP addresses assigned by one of the ISPs. On RFC it says that Private AS should be used only when singlehomed.Can someone give me any explanation about ...
I have experienced the following problem on gigabit interfaces, I hope that you can help me solve this one.00:00:09: %RP-4-DOWNREV_FABLDR: Slot 4 ROM fabldr too old; downloading from bundle00:00:09: %RP-4-DOWNREV_FABLDR: Slot 5 ROM fabldr too old; do...
hi,I tried before to NAT private addresses to public on cisco 7200 NPE-300 but it couldn't handle that. So my question is, which is the best Distribution layer Router Series with what hardware specifications that has the best performance on NATing ar...
Hi,I have the same error message,"Adding shape will make bandwidth allocation among pvs ambiguous " I've checked cisco documentation but didn't find something useful that can alleviate or explain this problem...Does anyone can help me with some infor...
first be sure that the GRE tunnel works properlythen you must apply crypto map on the tunnel.If this isn't helpful, please give us more details, like the configuration itselfBest RegardsMesut Abdurrahmani
I tried to block kazaa2 and it was successful, but I don't know why it experiences you problems, I would propose you to try to block the fast-trackclass-map Xmatch protocol fasttrackalso another solution is to block on http with stringmatch protocol ...
to achieve the load balancing you desire, you must use either EIGRP with ISPs which is not preferable, so that you can use EIGRPs unequal load balancing feature, to use BGP and to advertise some subnets to the first ISP ( 4mbit )that the traffic they...
