About Tim K

Tim K · 05-14-2020

I would like to know if there is a way on a P router to view the VPN traffic that is flowing through an interface. I have enabled Flexible NetFlow on the interface in both the ingress and egress direction, however, the only Netflow that is being capt...

Tim K · 11-13-2019

We have an MPLS network in which a few of the P routers are connected to each other via GRE over a service provider. We are running MPLS IP over those GRE tunnels. We have configured an outbound QoS Shaping policy on those tunnel interfaces. However,...

Tim K · 05-09-2016

I currently have a Cisco AP running in adhoc mode. I want to expand my coverage in my house, and allow for seamless roaming. Do I need a WLC to do that? Or can I run two APs in adhoc mode and roam between them? If so, are there any specific configura...

Tim K · 08-23-2015

I was wondering if there is any support for virtual links in the IPv4 address family of OSPFv3. Has anyone seen it? I saw one article on Cisco's website that it isn't supported, but maybe it's an old article? Has anyone been able to make VL's work in...

Tim K · 10-23-2009

Hey all,I am running into a scenario where I need to perform port address redirection for external users accessing an internal VoIP server. Configuring port address redirection is easy enough when you are dealing with one port mapping to one port. B...

Tim K · 06-02-2020

Thank you for the reply Guiseppe. How would I go about getting the information on the ingress PE router? I have a PE router that has 3 interfaces to other P routers. I would like to get an idea of what customer traffic is going down what interfaces. ...

Tim K · 11-14-2019

OK, I have an update. I found that some routers (version dependent) allow for the use of an outbound QoS policy on a GRE tunnel that runs MPLS and matches MPLS EXP values. My router, unfortunately did not support it. Luckily, I was able to find a wor...

Tim K · 01-17-2019

I had the same issue. I found a bug that has the fix action. I have pasted the results of it below for those that don't have a CCO account. Removing FALSE from the field listed below fixed the problem for me. ISE "Failed Value for attribute Protoco...

Tim K · 05-09-2016

Is any additional configuration required for it? Would they have to be on the same channel?

Tim K · 08-23-2015

Thanks for the response. I was hoping that maybe creating an IPv6 VL would allow the IPv4 routes to be learned. But I tried earlier to create a virtual link on the IPv6 side, which I did successfully. However, that did not help my problem. I still co...

Member Since	‎07-02-2008 07:00 PM
Date Last Visited	‎05-06-2022 12:04 AM
Posts	24
Total Helpful Votes Received	20

User Statistics

User Activity

Netflow Support for MPLS L3VPN

QoS over GRE Tunnel running MPLS

Do I need a WLC for Client Roaming?

Virtual Link for IPv4 Address Family in OSPFv3

Port Address Redirection

Re: Netflow Support for MPLS L3VPN

Re: QoS over GRE Tunnel running MPLS

Re: Import Network Devices into ISE 2.4 Authentication Protocol Required?

Is any additional

Thanks for the response. I