Hi
Device
NAME: "Chassis" , DESCR: "Cisco Aironet 1850 Series Mobility Express"PID: AIR-AP1852I-Z-K9,
Product Version.................................. 8.2.100.0
My problem
Last Reset....................................... hardware watchdog reset
S...
HiI have bought 10 brand new WS-C4510R+E. SUP 8E-10GE and 8 x 4748 blades per chassis.At first it ran without a problem, then the ports stop giving out power for the phones.I have enough power to support them.Power Summary Maxim...
Rob
What is the future for the MSE? I see they said CMX is the upgrade, but in the documentation they clearly state, not suitable for aWIPS functionallity. Meaning WIPS stops at version 8.0.150. We basically only used it for WIPS function. I can't...
Hi
What I did.
I went under Administration>Dash Board>Job Dashboard>APIC-EM Integration
I suspended the APIC-EM Site Sync.
Then cleared my system alarm.
Note: I don't have a APIC-EM device.
Alarm cleared now as you can't sync to a device that doesn...
Hi
Same here. Also upgraded from 3.1.5 to 3.3 patch 1. I also saw that when I added a floor plan under New Maps, it showed up on the old Maps. The new Map location is a blank page when I look at the floors. Up to building level Maps is fine.
Maarten
Just to say thanks. I tried to get this running for 4 weeks now in the lab. Sorted straight away. I knew it was something I miss on the WLC. Spend allot of hours on this. Thanks for the link.
