kritskiy_monstr
Level 1
Level 1
Member since ‎03-14-2006
‎08-18-2017

User Statistics

  • 23 Posts
  • 0 Solutions
  • 10 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

Hello!I'm trying to configure GVRP between two SPS224G4 switches, but without success.Switch A, port e24 is connected to Switch B, port e1sw3# show runinterface ethernet e24description sw4:e1exitinterface range ethernet e(1,24)switchport mode trunkex...
Hello!Is it possible to log URLs from HTTP requests on ISR with ZBPF without external URL filtering server?I tried following configuration!parameter-map type inspect par-Inspect-HTTP audit-trail onparameter-map type regex par-URL pattern .*!!class-m...
Hello,there is a call hanging on my CCME:3694 : 10399 2002968800ms.1 +1730 pid:20014 Originate 142 active dur 20:04:35 tx:0/0 rx:0/0 Tele 50/0/8 (10399) [50/0/8.0] tx:0/0/0ms g711ulaw noise:0 acom:0 i/0:0/0 dBmI cannot clear it with command "clear c...
Hello,I have a two dial-peers:dial-peer voice 101 pots destination-pattern 80679463149 port 0/1/0! dial-peer voice 1011 pots incoming called-number . port 0/1/0To port 0/1/0 incoming call arrives with no calling number. But as inbound dial-pe...
Hello,I have an 2811 router running CCME 3.2.I want to setup 7914 expansion module with IP Phone 7961. The phone loads normally, but expansion module doesn't load at all. All buttons are red.What should I put in ephone description on CCME to make 791...
Community Statistics
Member Since ‎03-14-2006 06:11 AM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 23
Helpful Votes Given To