About ceezr1997

ceezr1997 · 10-19-2011

Hello everyone, n00b here.As the title reads, I need help to alow ports 18082 and 18086 inbound to one of my internal servers.I pretty much now how to create a static nat rule but I dont know how to only allow those two ports. I dont want to open th...

ceezr1997 · 12-10-2010

Hello everyone, n00b here.We had a cisco tech help us out today so it wasnt I, the n00b, configuring the routers and ASA.So let me explain.We have a domain with 3 childs, all in a Paetec MPLS. One of these childs was taken out of the MPLS today and ...

ceezr1997 · 12-01-2010

Hello everyone, n00b here,We have an 1841 running IOS 12.3(8)T5 and need to upgrade to an IOS version that supports vpn.under cisco downloads and i go to products - cisco ios - and then the following are listed:Cisco IOS Software Release 15M&TCisco I...

ceezr1997 · 11-23-2010

Hello everyone,disclaimer...n00bOne of our remote offices is going from a multilink (3xT1s) to a single link T1 configuration. The router was originally setup by our network ops guy (who's no longer with us, nor reachable) and we have no idea how to ...

ceezr1997 · 10-20-2011

it worked, I am good to go!thank you for your help!!!

ceezr1997 · 10-20-2011

thanks for the reply jcarvaja.to clarify - I will have TWO NAT rules under my NAT Rules section, one for each port configured as stated above.then I will go to my Access Rules and apply those two ports to that outside IP address?I currently have an ...

ceezr1997 · 12-01-2010

thanks for your prompt reply.When I select Cisco IOS Software Release 15M&T as the options of IOS's I end up with this one: 15.1.3T(ED). Is that ok? What is the diff with the T's, M's (ED) and other letters in them?Then when I click on 15.1.3T(ED) ...

ceezr1997 · 11-29-2010

Rick, thank you for the detailed reply, to answer the Q's; yes, we arekeeping the same ISP, they are just removing two of the T1's and leaving uswith a single T1 using the same IP address.Now for an additional questions that I dont know if the ISP an...

ceezr1997 · 11-24-2010

ok, all points taken. seems easy enough to do.sorry but I have a follow up, can we do this before our ISP does the change or can we have this already prepared so when we go to a single T1 the router is already up and running?and what would happen if...

Member Since	‎11-23-2010 03:52 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	13

User Statistics

User Activity

Help-need to allow ports 18082 and 18086 inbound (ASA5510)

LDAP communication through cisco site-to-site VPN

Need to upgrade IOS on 1841 router to support point2point vpn, pls help!

n00b-How to config multilink to single link on 2801 router

Re: Help-need to allow ports 18082 and 18086 inbound (ASA5510)

Re: Help-need to allow ports 18082 and 18086 inbound (ASA5510)

Re: Need to upgrade IOS on 1841 router to support point2point vp

Re: n00b-How to config multilink to single link on 2801 router

Re: n00b-How to config multilink to single link on 2801 router