Hi,I want to configure the Fxs user to dial-in to Fxo and then selecting the desired extension to connect to.i dont need welcome message or hunt group. is it possible with below and when dialing in it gives an error of application not found. applicat...
Hi,I would like to have a simple configuration where if someone makes an inbound calls to FXO port it should ring and then inbound caller must dial an extension. i do not need any Auto Attendant etc. Using CME 4.0 on router 2921.Help would be really ...
Hi,I have a router and NVRam seems to be damaged or corrupted Cisco 2921. Can we change the NVRAM ram physically? because i changed the cf card and still doing the same. Router#wrBuilding configuration...[OK]Router#*Sep 14 15:11:35.471: %NVRAM-2-NO_G...
Hi,I have configured Dlink DP-150S IP PHONE using SIP protocol and all is working fine.Only issue i am having is Randomly IP Phones start sending missed calls (two rings) to each other many times in a day then stops and starts again with another num...
Hi,I would like to assign two PSTN numbers to be called from a specific DN.For Example, DN = 112 should only make calls to following numbers only.+256700400100+256700400101 Thanks in Advance,Nooruddin
Hi please see my config below and error i am getting. applicationservice aa1 flash:app-b-acd-aa-3.0.0.2.tclparamspace english index 1param aa-pilot 101param max-extension-length 3param number-of-hunt-grps 2param handoff-string aa1param dial-by-extens...
yes Nithin is right. i have downloaded the pdfbut can you help me identify the IOS version for C3845-MB router which has cme version above 4.3 because param and application command works minimum with this version and later.