Hey Udi,Its been quite a while, I hope all has been well?Unfortunetly in native IOS there is no "auto sync" feature for files between the supervisors. So when performing an upgrade you will always need to copy to the active, then execute another "co...
Eric,You are thinking in a layer 2 mindset and not allowing for the functionality of the layer 4 protocols.If you wanted to upload a file to an FTP (a TCP based application) for example, it does not throw the packets out at line rate, remember that i...
Eric,If I understood the question correctly, then the answer depends. If your hosts are currently 100Mb while your servers are already 1Gb, then you were to upgrade the hosts you would likely see worse performance. The main reason for this is the TC...
1) Correct, both the N5K and N7K just use MGMT02) I was not sure here if you meant connecting the N7K/N5K to a 6500 from a network traffic perspective, or if you mean connecting the MGMT interface to the 6500? If the former, on the N7K it depends on...
Abebe,Gotcha, In that case either put everyone in one VLAN from the 6500 perspective, and use a secondary IP address on the subinterface of the 2821 (so you essentially have two network ranges mapped to one subint/vlan), or use one VLAN per memotec, ...