I applied the latest release of the Cisco firmware (7.4.6) last night and have come across an issue. The phones are not fully applying some of the configuration parameters specified in the provisioning template we use even though the settings show up in the web interface. For example I have a modified version of the connect call string that shows the bxfer button while on a call. This works just as needed when running version 7.4.4, but when version 7.4.6 is applied the phone show the proper settings in the administration web interface, but not on the phone itself. The phone shows the default configuration no matter what setting is applied in the web interface or provisioning template. The provisioning template shows this for the setting - <Connected_Key_List group="Phone/Programmable_Softkeys">conf|1;xfer|2;bxfer|3;phold|4</Connected_Key_List> The web interface shows this on the phone tab (advanced) when running both firmware versions - Connected Key List: conf|1;xfer|2;bxfer|3;phold|4 I am also specifying time settings, which also work in 7.4.4, but not 7.4.6. Any ideas on what to do? ... View more

I am running 60+ SPA504g phones with a 3cx pbx. I have basic 'option 66'  provisioning in place and that is working fine. It would be extremely helpful to be able to perform some more advanced configurations on the phones. Specifically, I would like to be able to set the softkey during active calls as well as being able to set line 4 to a shared extension (ext2 settings). The provisioning template that I am using is all XML and the only guide I  could find has no references to XML parameters at all. Is there any detailed provisioning examples that I could point me in the right direction? Are these parameters even available for provisioning control? Any help is greatly appreciated! Thanks ... View more