About jim_nickel

jim_nickel · 05-09-2012

I followed this guide:https://supportforums.cisco.com/docs/DOC-8582And it worked, but I have 2 problems.1) The blade being put into Standby starts back up immediately - almost like a reboot -and doesn't stay in Standby mode2) The Blade being put into...

jim_nickel · 03-13-2017

Is it possible to use UCS director with this UCS Platform Emulator? I would like to build a test environment to learn UCS Director and I am using vSphere.Thanks,JIm

jim_nickel · 05-09-2012

Ok...here it is.....I think I picked the right CIMC ID - but I couldn't find the right spot to find the CIMC ID #, but it is chassis 1, blade 1, so I used CIMC ID 1.Jim

jim_nickel · 05-09-2012

ESXi 5.0.0, 623860 - Nothing in the logs that shows VMware is sending another signal - only the Standby signal. In fact, it thinks it succesfully put it into Standby mode as the blade goes unresponsive for long enough.BIOS: B230.2.0.1d.0.1116201115...

jim_nickel · 05-09-2012

Sorry...not the case. We have 10 Blades and they are highly under utilized. Plus, DPM is in Manual mode right now.I am testing and have not done a successful test...in other words, I have not been able to "Power On" because it won't stay down.Jim

jim_nickel · 05-09-2012

I followed this and it works with vSphere 5, but when I put a Blade into Standby through the vSphere client, the Blade shuts down and then powers back up right away. Almost like a reboot.Any ideas how to get it to stay in Standby mode?Thanks,Jim Nic...

Member Since	‎05-09-2012 07:22 AM
Date Last Visited	‎04-09-2020 10:17 PM
Posts	4

User Statistics

User Activity

Cisco UCS Blades and vSphere DPM

Re: Cisco UCS Platform Emulator 3.1(2bPE1)

Re: Cisco UCS Blades and vSphere DPM

Cisco UCS Blades and vSphere DPM

Cisco UCS Blades and vSphere DPM

Re: Integrating Cisco UCS with vSphere Distributed Power Management