Hi! Is there a way to filter OSPF routes without the "Area" command?I could swear I've done it before, but I can't seem to replicate it again.I am in CML, and my topology is R1--R2--R3.Link between R1 to R2 is area 0, R2 to R3 area 1.From what I reca...
Hi! I am sitting with a topology of:PC1 -- SW1 -- R1 -- SW2 -- PC2I am trying to configure a GRE tunnel between SW1 and SW2, but I cannot manage to make it work. Can someone help out? See below config. I have been fooling around a bit with the routes...
The link between R1-R2 is removed, but R1's loopback is still visible on R4."Ip prefix-list NOR1 deny 12.12.12.0/29""Ip prefix-list NOR1 permit 0.0.0.0/0 le 32""Distribute-list prefix NOR1 in" on R3The route to 10.10.10.1 (R1's lo0) is still visible ...
Managed to make it work again. I added another router:R1--R2--R3--R4.I made a prefix-list on R3 denying the link between R1 to R2 from being advertised to R4. On R3: "Distribute-list prefix prefix in", R3 being ABR between area 0 and area 1, this pre...
