Cisco Community
English
Register
Great changes are coming to Cisco Community in July. LEARN MORE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
sdoremus33
‎08-18-2017

Participant
Recent Badges
Awards
Recent Badges
See all
1 Accepted Solution
30 Helpful Vote
1 Helpful Vote
10 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies
Stats
Member since ‎03-23-2005
279
Posts
53
Helpful
3
Solutions

Cisco ACE 4710 + Round Robin Predictor

Created by in Application Networking
05-11-2012
05-11-2012
One thing I found was under policy map policy-map multi-match VLAN10 class VS-ETmail loadbalance vip...

Re: IPSEC transport mode and GET VPN

Created by in Network Security
11-04-2009
11-04-2009
One thing to understand about Tran sport mode vs Tunnel mode (ipsec) is thst Transport is used betwe...

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-04-2009
11-04-2009
One last ides for troubleshooting as I mentioned earlier you can try to add the dynaimc crypto map t...

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-04-2009
11-04-2009
Another troubleshooting ides is to turn off Nat-T no crypto isakmp nat-traversalSee what happens que...

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-04-2009
11-04-2009
I hope some of these issues help you out as I am running into a very similiaer situation .I notice i...

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-04-2009
11-04-2009
This looks like an issue with NAT primarily with the dst @172.x.x.x.One thing you could also try for...

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-04-2009
11-04-2009
Just curious what are trhe outputs from the following commands IPSEC Commands sh crypto isakmp sa sh...

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-04-2009
11-04-2009
For the following statement: But as you can see int thu hub's FE 0/1 config I have a private IP addr...

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-04-2009
11-04-2009
The configuration looks good, however I would try one another command on the spoke router Set securi...

Re: asymmetric nat?

Created by in Network Security
11-04-2009
11-04-2009
Is there any way to access a host using BOTH natted AND real IP addressIf there is I am also curious...

Re: asymmetric nat?

Created by in Network Security
11-04-2009
11-04-2009
You can have a look at this document which describes NAT order of operations. http://www.cisco.com/e...

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-02-2009
11-02-2009
Spoke router ip nhrp network-id 50Hub router ip nhrp network-id 100

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-02-2009
11-02-2009
One other question in your MGRE config your network is between HUB and Spk1 , Spk2 correct, one othe...

Re: DMVPN ISAKMP phase 2 SA policy not acceptable!

Created by in VPN
11-02-2009
11-02-2009
When you defined the dynamic crypto map, did you integrate this into the static map. Ex: Step2: Defi...

Re: GRE and IPSEC

Created by in Switching
10-03-2009
10-03-2009
Thanks for the helpful information Rick as always
Public Statistics
Date Registered ‎03-23-2005 11:51 PM
Date Last Visited ‎08-18-2017 03:55 AM
Total Messages Posted 279
Total Helpful Votes Received 53
Helpful Votes Given To