In trying to get per VC queueing going on my 6513 with a WANFlex WAN adapter I got the following message:switch#sh queueing interface atM 3/0/0 vc 1/51VC 1/51: Per VC queue is not enabled.Am I right in assuming that this per VC queueing is possible o...
We need to use the SFP ports on the supervisor modules, problem is that they are on inactive rather than nonconnect.Probably an easy one...switch#sh modChassis Type : WS-C4510RPower consumed by backplane : 40 WattsMod Ports Card Type ...
I had a dig around today on the software center but could not find a boot image for this blade, does such a thing exist? Would prefer a 12.2 image if possible...
Problem turned out to be some old config within a tunnel interface. This was one tack which was tried before but not properly deleted.Deleted the tunnel interface and the SA came up straight away!
I'm looking to get any clue to tell me that per VC queueing is working. There is a QoS document on cisco's website just for the FlexWAN module and I've followed it to the letter but per VC queueing is disabled as reported by my output in my original ...
It sounds like you've been given 24 channels of connectivity i.e. 1536k rather than a T1 end to end (1544k)Hopefully on the E1 end you'll have timeslots 1-24 (timeslot 0 is for framing) which will turn up in the US. You'll need an E1 interface in Swe...
