Hello, is it possible to forward ports / services to 1-1 natted computers?
One-One NatExternal IP Internal IP
71.44.55.66:3333 -> 192.168.1.101:338971.44.55.67:3333 -> 192.168.1.102:3389
I've tried all kinds of stuff and cannot get it to work...
Hello, I found the odd place to put port translation, however it only seems to work for the primary IP address on the router.My setup with muliple IP addresses192.168.10.11~37 =>202.50.74.195~212 (external IP addresses are fake)Port 3333 is forwarde...
Hello, I have some confusion with the RV082 default rule,Deny,All Traffic [1], Wan1, Any, Any, Always This default rule does not seem to have any effect on One to One Nat.. All traffic appears to be allowed from WAN to LAN.Is it correct to assu...
Hello, I have RV042, and it is working fine with four IP's I was assigned and 1-1 Nat.The first four IP's they gave me were in the range of 67.23.132.XXX.Now I need more IP's and they assigned me66.7.192.xxxand66.7.199.xx66.7.203.xx66.7.208.xxI can'...
Hi, I hope someone can give me an example of what I need to do, if possible with the RV042Primary External IP address uses port forwards for some ports, all okay.I would like to have other external ip addresses assigned to machines on my lanBasic hos...
This is a year old, nonetheless, you may find setting the MTU to 1492 or some other number will help. I had the same problem and took hours to troubleshoot. There are tools to test what MTU you should have, and for 50 + MBPS, the default 1500 does n...
I just posted a question in regards to this for confirmation. Yes, it would be helpful to have documentation that would clarify this and save many people countless hours fingering it out. Its complex enough already, and without this hint for someon...
You are the man! All about the priority, thanks.Now if there was just a dummies manual for these routers, it would be great. QuickVPN aint so darn quick with the innstructions that are given. The documentation should be called, "clues" to setting...
PS Everyting is working fine, except the default is all ports are default open for one-to-one nat.I want to have all the ports closed, except a few. The setup below does not seem work..Priority PolicyName Enable Action Service Source Destination Ti...