I have a 2960 with a following relevant config:interface Port-channel1 switchport mode trunk!interface GigabitEthernet0/1 switchport mode trunk channel-group 1 mode active!interface GigabitEthernet0/2 switchport mode trunk bandwidth 1000000 channel-g...
Hi,In my central location, I have a network with ASA, two 3750's as core/distro switches and a couple of 2960's as access switches. I have also one 1841 to server some special functions and as a ASA backup.At branch office, there are a 1941 as core/d...
I have following situation: Host connected to switch port 0/1 and address 192.168.139.38 255.255.255.252, and connection between switch port 0/2 and asa port 0/1. Relevant configuration is:Switch config:!spanning-tree mode pvstno spanning-tree optimi...
I have two 2960 switches connected with two links. One of them is transparent modem connection with 2Mbps limit, and the other is optical link with media convertos on both sides. Is there a way to set up etherchannel, LACP or any other kind of link t...
What this debug message actually means? Shouldn't encapsulation add 24 extra bytes or not? For what reason encapsulation is not adding bytes to original packet in this debug message?
3750#show cable-diagnostics tdr interface gigabitEthernet 2/0/24TDR test last run on: May 15 11:10:27Interface Speed Local pair Pair length Remote pair Pair status--------- ----- ---------- ------------------ ----------- --------------------Gi...
And on the 1941:!interface GigabitEthernet0/1.777 description Management encapsulation dot1Q 777 ip address 192.168.1.xxx 255.255.255.0!Thanks for help!
Thanks for reply.Our requirements are 50 Mbps via fiber line, so I believe that 1941 will handle it well, including the fact that there is no encryption, no PBR, only couple of ACL and one GRE tunnel.And one more question: I fullfiled both ethernet p...
ASA Version 7.2(3) !hostname asadomain-name default.domain.invalidnamesdns-guard!interface Ethernet0/0 no ip address !interface Ethernet0/1 nameif line2 security-level 100 ni ip address!interface Ethernet0/1.1 nameif line security-level 100 ip addres...
