Hi,
I have the same problem. I debugged the aaa session on the WLC and Service-Type 7 showed up in the authorization result however ISE policy is configured with Service-Type Administrative.
This must be an ISE issue, the authorization result is con...
Some heads-up about cert authentication. Today I realized that Anyconnect installation through the ASA website works only if you use the configured Group-URLs to access the ASA. If not Cert validation failure message comes up.
Hi Jon,
we have been struggling with the exact same problem for weeks but we had found a solution. Just to be sure the symptom is the following: the initial VPN connection using the hostname of the ASA without a downloaded profile succeed but connect...
Cisco WLC 8.2.100
ISE 1.4 patch 6
Similar ISE Hotspot setup, similar rules except the VLAN change. I observed the same behaviour.
This setup was working on patch 5.
Update:
I found a workaround based on the following bug. Use the attribute below in ...