Hello experts,I have an strange issue with LDP label mapping message. In my lab I have 3 routers. Asr903 and ALU are PE, while asr9922 is P router. I have create xconnect session between asr903 and ALU PE. What I found is asr903 send LDP label mappin...
Hi,I have the topology where ASR9K bundle interface is connected with ASR900 port-channel interface and use BFD signal but the port never come up, below is the detail. ASR9K => IOS-XR 4.3.2, linecard: A9K-MOD80-TR, A9K-MPA-4x10GEASR903 ...
Hi Expert,I have ASR9010 with single incoming interface(GE) and two outgoing interfaces(TenG1 and Bundle-E(TenG2)). the routing/cef/label is configured to forwarding traffic out TenG1. All interfaces are configured with MTU 9194.- When I inject traff...
Hi, ExpertsEquipment: Cisco ASR9922, IOS-XR 4.3.2 Issue: I have problem that my RR do the next-hop-self by using route-policy for client routers, the next-hop is changed as intended but the MPLS label doesn’t changed to reflect the new next-hop.Wha...
Hi guys,Nice video, do you have any tip for implement BFD between ASR903(port-channel) <==> ASR9K (bundle-ethernet). I try and it only good between PO-PO and BE-BE but can not get PO-BE works.Regard,Marit
Hi Rivalino,That's answer the issue i'm faceing, anyway i'm looking into the work around..If we go back one step further, the reason I do this isAN-AN communication: I would like it to take shortest path in golbal-routing instead going back and forth...
