Hi..Question: I want to Check Particular command is present in switches through ciscoworks2000.See i checked that it is possible in LMS 3.1 via RME-Compliace check and i have already did that but  i want to achieve Same function in ciscoworks 2000.

CM version : 5.1.3Attached file shows Link Trunk/Nontrunk error and switch output.As seen in error 1, Gig 0/2 of one switch is connected with Fas0/1 of other.but it's not the case.Actually Gig 0/2 of one switch is connected to Gig 0/1 of other and al...

While seeing on CM discrepancies it shows Link Trunk/NonTrunk Mismatch error on fas 0/1 of so and so switch but actually that port is of Gig0/1 rather than Fas0/1.On basis of which output CM shows descripancies result?what could be done to stop wrong...

We have LMS 3.1 installed and configure IPM threshold setting on rtt.Now it notifies violation to LMS server on IPM screen whenever there is any violation occur but at the same time i want my switch will send the same trap to my third party syslog se...