Forgive my ignorance, I am new to the PIX firewall configuration. Here's what I'm trying to do. I have a proxy server (Microsoft ISA Server) in my DMZ with an address of 192.168.2.2. My DMZ interface address is 192.168.2.1. My Inside interface ha...
I was wondering what the best method for going about routing traffic from certain IP addresses over a specific WAN link would be. I have a 2621XM router with 2 WIC-1DSU-T1's in it. I want to enable it so that one of the T1's is only used for routin...
I was wondering if anyone else ever ran into this problem. I have 3 AS2509's configured on my network. When I go to install a Catalyst 3550 on the network I get a CDP-4-DUPLEX_MISMATCH error message on the 3550 with the Ethernet ports on the 2509's...
I'm not sure if this is a Cisco problem or a Microsoft DHCP server problem. I have 6 VLANs setup being routed by a Catalyst 4507R and DHCP scopes configured for each. My problem occurs when I move a node off of one VLAN onto another. If Device A i...
So this will allow one way access from my dmz server to the dns server on the inside network right? I assume I have to set an access list as well in order to allow port 53 access?Jo
I've actually looked at both of these articles already but I still couldn't get it to work. I believe the statement I need is static (inside,dmz) and then the ip's but I'm not sure how it is suppose to be structured. Any other ideas?Thanks.Jo