About l.cantrell

l.cantrell · 10-30-2017

I'm trying to get a POC up and running with APIC-EM for IWAN. our HUB site consists of new ASR1001-X routers connected to MPLS and Internet, with a ISR4431 for the PfR MC. They are running the Denali 16.3.5 release and when I run through the configur...

l.cantrell · 09-16-2008

In CME I have a hunt group setup so that when someone calls in to the main line it rings ephone 10 if no answer it rings ephone 11. If no one answers these phones it will ring an on a cell-phone that the on call shift has. However, somehow the first ...

l.cantrell · 07-03-2008

I have a 1310 that I need to convert to autonomous IOS mode. For this I have the 1310 connected to a 2100 WLAN controller. The problem is when I run the config ap tftp-downgrade command the ap returns the following error messageexamining image...%Err...

l.cantrell · 02-29-2008

I'm having an issue with an ASA 5505 not redirecting packets that enter it's inside interface to be redirected back out it's inside interface to a second network. The way it's currently setup is that the ASA has it's inside interface at 192.168.2.1 ...

l.cantrell · 09-20-2018

Ahh, you're running FTD software and not ASA code with an SFR module. With the FTD software, you don't define security-levels as there is just a single global access-list called an access-control policy that is used to control traffic. Inside that po...

l.cantrell · 09-19-2018

By default, the security level for an interface is 0, with the one exception being the inside interface which will default to 100. However, you can change any of these by using the security-level X command on the interface. For example, if you want t...

l.cantrell · 07-03-2008

Ok fixed the issue when I tried to do the tftp-downgrade to the a 12.3-7JA version it worked without complaints. Thanks for all the help.

l.cantrell · 07-03-2008

Same issue the controller can see the ap but if you try to make any changes like changing the name etc. it returns Cisco AP name is invalid. If I do a show ap summary it list the ap with the name ap1 right IP and mac address though.

l.cantrell · 07-03-2008

Ok I attached the AP and the laptop running the tftp server to a 2960 switch. I can ping everything now. However, when I run the config ap tftp-downgrade command I get a invalid AP name. The AP is called ap1. Why does it say that it is invalid?

Member Since	‎11-30-2007 09:55 AM
Date Last Visited	‎12-26-2020 12:34 PM
Posts	12

User Statistics

User Activity

IWAN App stuck at configuring HUB site

Ephone logged out of hunt group

converting a 1310 to autonomous IOS mode

Route redirecting

Re: Change Security Level in ASA 5508x with Firepower Services 6.2.2

Re: Change Security Level in ASA 5508x with Firepower Services 6.2.2

Re: converting a 1310 to autonomous IOS mode

Re: converting a 1310 to autonomous IOS mode

Re: converting a 1310 to autonomous IOS mode