Hello all, I would like to know what is the default port range of source NAT overload on a Cisco router ? <1024–65535> ? So, this command "ip nat settings interface-overload port range start <1024–65535>" allow me to limit or increase the default r...
Hello all,I am looking forward to pass CCDP arch 300-320 to renew my CCNP R&S.I just want to know if there direct questions only or LABs with configuration CLI also ?Thank you for your help !
Hello all,I have a question about PBR (using route-map)If we have two gateway (1 and 2) to reach a network A, and if a packet matches a route-map but the gateway (1) which is specified in the 'set ip next-hop' command is not reachable. So my question...
