Hi experts,
I have a problem with netsim because I am trying to configure vrrp in a simple topology and it doesn't work.
I guess that Netsim maybe not support this feature but I need to confirm that information.
Anybody knows where I can find all the...
Hi experts,
My doubt is pretty simple.
What happend with the commands of err-disable recovery.. on IOS XE?
How I configure:
err-disable recovery cause link-flap
err-disable recovery cause psecure-violation
err-disable recovery cause udld
For example?...
Hi experts.
My doubt is so simple, I have a topology like this:
PC1----7600-1----7600-2----ASR9k1----PC2
Considerations:
- Both PCs are in a vrf A, because of that 7600-1 and ASR9k1 are PEs
- ASR9k1 and 7600-1 have a BGP session with VPNv4 and IPv4...
HI Milos, thanks for your answer.
But my question is, these procedure that you comment, obeys to the procedure that in IOS I can apply, but in IOS XE these commands aren´t present. Then, the real question is:
Are there any synonymous commands in IOS ...
Hi Alek, thanks again.
At this moment I don´t have access to the devices to do this test. As soon as I have access again, I will probe your idea.
Thanks a lot.
Daniel
Hi Alek, thanks for your comments.
Yes, I confirm that, when I use physical and subinterfaces L3 between ASR9k1 and 7600_2, the topology works! keeping the interface towards PC2 in BVI.
Let me share with you some outputs with the change of the top...
Hi Eddie,
in accord to your recommendation, I try to change the allocate label mode to per-vrf and the result is the same :(
Any other idea my friend?
Thanks in advance!!!
Daniel.
