Is it normal for a switch to have both the interface bia MAC address and the VLAN MAC address of the connected switch in its table?
I have a 2960 connected to a 3850 in a trunk. The 2960 has a layer 3 vlan(20) configured with an IP Address. I connect...
This is driving me insane.
I've looked at multiple posts, nothing works.
I just want access to vty lines from my inside network.
The latest:
ip access-list standard Inside-Machinespermit 10.10.0.0 0.0.255.255
line vty 0 4access-class Inside-Mac...
I have attached a diagram and router configurations.
We have a Primary Internet pipe(Blue) and a Secondary Internet pipe(Red) to the same ISP.
eBGP is running on the internet interfaces and iBGP is running on the inside interfaces.
We are receiving t...
I found that I didn't have the correct boot statement and ended up with:
Switch:
After considerable time and research I brought the switch back.
You need to have a workable USB stick with the Switch Image loaded.
These were my steps. I hope this may...
Tried booting from usbflash0, stuck in a loop...help!
switch: dir usbflash0:Directory of usbflash0:/ 1 -rw- 303772864 cat3k_caa-universalk9.SPA.03.06.06.E.152-2.E6.bin3705896960 bytes available (303824896 bytes used)switch: boot usbflash0:cat3...
I tried this it doesn't take on the new 3850.
3) On new new switch change switch member number and priority to the old switch member number and priority ( you can find this on the live stack by sh switch command as the provision from old switch shou...
Thank You, Thank You, Thank You!I had just "priority"configured as well. Once I added priority level 1, I could apply it to the interface. Bangs head.....
Could this have anything to do with IOS-XE version?
Technology Package License Information:-----------------------------------------------------------------Technology Technology-package Technology-package Current Typ...