Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Don,Been testing the RV110W and I have to say it is a cool little box. I have, however, found a few things that need to be revised and enhanced. I am using the latest firmware you provided:1) Clicking on "Help" button forces you to re-login only to s...
Efrat and Marco, I thought I would drop you a quick note to let you know that we had an interesting event last night. We needed to upgrade the code on a UC520 at a customer site that has a Thunderbolt installed. We used the Thunderbolt to sucessf...
1) I am unable to access the support page from the support link of the Thunderbolt Portal. It appears to prompt for a CCO ID and password but never logs in. I am able to log into the Thunder Portal itself with the same CCO ID and password.2) It rea...
The "match interface" under the route-maps are not required. In fact, you can use just an "ip nat inside" statement and point it to acces list 110. Also, under "ip sla" I would track the reachability of the default gateway for that connected interfac...
Give the primary route a lower administrative disctane than teh backup route. Remember to use SLA tracking to detect when the first interface becomes unavailable.Thanks,Marcos
Routing would fix this. I mean, a routing decision (outbound interface) is made prior to NAT'ing. Static route preference would be the way to go, or policy based routing, which is a little more complicated. Try to experiment with this and let me know...
The switchport would still be an access port, so no tagging.Take a look at an article I wrote a while back for ideas on how to configure redundancy vs. load balancing:https://supportforums.cisco.com/docs/DOC-9423Glad to help! Let me know.Marcos
