I have a chassis with four B200 blades running 2.0(2q) code. ESXi 5 is running on the blades. There are two UCS managers in a cluster and I wish to upgrade to 2.0(3a)I upgraded the code from 1.4 a few months back but the system was new and wasn't run...
Hi,I have two MDS 9148s in a Production. One MDS is in VSAN 2 and the second in VSAN 3. Both have zoning and zone sets configured and are not connected ie no ISL between them.I have two MDS 9148s in a DR Site and want to link MDS1 in Production to MD...
Hi,I want to upgrade the IPS module in an ASA 5510 and have a few questions. The AIP-SSM is running 6.2(1)E3 479.0 and I have a valid CCO account etc for this.Does the Software version on the ASA matter?When I look in software downloads < IPS there a...
The VPN isn't coming up. I configured the ASA manually and used the SDM for the router, hence the poor naming in my config. The ASA protects 191.1.1.0/24 and the router protects 192.168.1.0/24Any help would be great as this is wrecking my head. The r...
HI,I have a few public facing interfaces on an ASA and have found that when a connection comes in through an interface that isn't the default route for the ASA, I get an error stating that no route to x.x.x.x from x.x.x.x (interface).When I add in a ...
Hi,Thanks for the reply. You have described the setup as I plan to configure. I have the E ports ready and ZoneSet distribution is enabled.I will enable enhanced zoning, just have basic at the minute.I had read the white papers but am un-sure about t...
Hi,I go to Products < Security < IPS < IPS Modules for ASA < and the only option is Cisco ASA Advanced Inspection and Prevention Security Services CardMust be a link missing using the software download tool on the site. I followed your link and can s...
ThanksGuys,When I try to upgrade to IPS-SSC_5-K9-6.2-3-E4.pkg from the GUI and CLI I get "cannot upgrade the software on the sensor. This package cannot be installed on the SSM-IPS10 platform" I am downloading it from under the ASA modules sectionThi...
