About penguinunix

penguinunix · 08-07-2024

Hi,I just want to know how can I apply ip nat outside on interface with OSPF enabled:interface GigabitEthernet0/0/1description P2P_to_R2ip address 10.62.1.1 255.255.255.252ip ospf 10 area 0negotiation auto!--------------- OSPF config ---------------r...

penguinunix · 08-22-2024

Ouch that sad, hope that you can recover the configuration.

penguinunix · 08-22-2024

This is the latest NAT ACL applied:10 deny ip host 10.62.127.1 any20 deny ospf any any30 deny gre any any40 permit ip 10.255.255.0 0.0.0.255 any50 permit ip 10.255.254.0 0.0.0.255 anyLatest router-id config applied:router ospf 10router-id 10.62.1.1re...

penguinunix · 08-21-2024

Yes, I have tried all the suggested configuration here, and still OSPF state turn to INIT/DEAD as soon as applying ip nat outside.

penguinunix · 08-21-2024

As I informed, I have tried1 setting router id to Low (using ip address on the ospf enabled interface)2 already did that and get the same result.

penguinunix · 08-19-2024

Already did that, and still got DEAD/INIT state on the OSPF.

Member Since	‎08-07-2024 12:50 AM
Date Last Visited	‎08-25-2024 03:42 AM
Posts	29
Total Helpful Votes Received	6

User Statistics

User Activity

NAT over OSPF interface (CISCO ROUTER C8500L-8S4X)

Re: NAT over OSPF interface (CISCO ROUTER C8500L-8S4X)

Re: NAT over OSPF interface (CISCO ROUTER C8500L-8S4X)

Re: NAT over OSPF interface (CISCO ROUTER C8500L-8S4X)

Re: NAT over OSPF interface (CISCO ROUTER C8500L-8S4X)

Re: NAT over OSPF interface (CISCO ROUTER C8500L-8S4X)