Miguel,As per cisco documentation:1.) The PIX Firewall failover-only unit is intended to be used solely for failover and not in standalone mode. If a failover unit is used in standalone mode, the unit will reboot at least once every 24 hours until...
Hello,Ping started working because the previous static statement only permitted port 3389 traffic through. The more general static statement allows the translation to occur on all ports, including ICMP. What the successful pings does show is that t...
Avdhesh,You shouldn't run into any problems if the switch has a different domain name. VTP only communicates with other switches within the same domain. In fact, one way to reset the revision number of a switch within a network is to change the dom...
Nuno,You open access to these addresses by creating Access-lists and grouping the access-list to the outside interface. This can be done as follows:access-list outside_access_in permit ip any host 194.189.123.1access-list outside_access_in permit ip...
Hello Sanjay,I am assuming that this is most likely a result of you exceeding the maximum rule allocation for your specific device. The default for inspection rules of a FWSM in Single context mode is 4147. For multiple context mode it is 1417. Fo...