About shamimakhtar

shamimakhtar · 09-16-2010

I am trying to set up an IPsec VPN tunnel between a Cisco 1711 and Netgear FVS318 router/firewall. Phase1 is establishing but Phase2 is not. Debug output is provided below.Netgear Settings:Encryption: 3DES SHA-1 with Pre-share key, DH Group 2(1024 Bi...

shamimakhtar · 09-15-2010

I have a Cisco 1711 which I am tyring to configure as a small-office router. It will assign DHCP addresses to computers on the LAN and provide them internet access. Router receives an IP from the ISP modem and router can ping hosts on the internet. P...

shamimakhtar · 09-16-2010

i just took out AH as you mentioned, unfortunately it still does not work.

shamimakhtar · 09-15-2010

oh wow, that worked. i just changed and re-tested and it works like a charm.if you are ever in the NYC area i will be getting you a few beers

shamimakhtar · 09-15-2010

From the router I am successfully pinging internet hosts, i am able to also telnet to google.com on port 80 and it is resolving correctly.

shamimakhtar · 09-15-2010

that is correct - DHCP on the Fa0 (outside) interface is supplying a default route.The nat translations does nto show any output when i ping from the laptop. when i ping from the router NAT table shows as below. I changed thePro Inside global In...

Member Since	‎09-08-2006 05:02 PM
Date Last Visited	‎11-29-2020 08:33 AM
Posts	6

User Statistics

User Activity

IPsec VPN Problems Between Cisco 1711 & Netgear

Cisco 1711: Cannot get NAT to work

Re: IPsec VPN Problems Between Cisco 1711 & Netgear

Re: Cisco 1711: Cannot get NAT to work

Re: Cisco 1711: Cannot get NAT to work

Re: Cisco 1711: Cannot get NAT to work