About gavinr98

gavinr98 · 02-29-2024

Need a little help. I currently have 2 Cisco 9500's configured in a virtual stack, with one of the ports on sw1 configured as a layer 3 port to route traffic to our FW. What I would like to do is add another port from the 2nd switch that is in the st...

gavinr98 · 08-01-2023

Hope someone can help. I am working on changing the default vlan from 1. The problem I am having is as soon as I remove the IP address from the switch on vlan1, and add it to the new vlan interface, I can no longer ping the gateway from the switch. I...

gavinr98 · 05-19-2023

I am trying to connect an HP Nible SAN with a 4x10GB Ethernet Optical port to a Cisco 9500 C switch using a QSFP to SFP+ converter and using a 10 Meter 10Gb OM3 Multimode Duplex Fiber Optic Cable (50/125) - LC to LC. The ports are showing that the ha...

gavinr98 · 05-10-2023

I have 2 9500 switches and I am trying to connect the 2 together without a stacking cable. I have a 100GB QSFP cable connected to port 32 on each switch, I have a link light between the 2 connections, but I cannot ping from one switch to the other. D...

gavinr98 · 08-17-2022

Hope someone can help. We are testing out a new Cloud PBX and have ported some of our DID's that we had to this new service and need some help with a translation pattern when the 4 digit DN is called. For example, the number that was ported out was (...

gavinr98 · 02-29-2024

Thank you! I will give this a try. The connection is going to a 10GB FS switch, so hopefully it wont we an issue. We are going to split out the connections for HA to our FW's.

gavinr98 · 08-01-2023

That was it, everything is working now. Thank You!

gavinr98 · 08-01-2023

other than the trunk, there is no additional config.sh run int hu1/0/3Building configuration...Current configuration : 57 bytes!interface HundredGigE1/0/3switchport mode trunk

gavinr98 · 08-01-2023

We are using a Sophos XG as the default router which is connected to the 9500 port 3. Here is the config from the switchport. Could the fact that the access mode vlan is still pointing to 1?WTCPASCORE01#sh int hu1/0/3 switchportName: Hu1/0/3Switchpor...

gavinr98 · 08-01-2023

Yes, I changed the IP on both the 9500 and 9300 Vlan. I will clear arp and mac to make sure.

Member Since	‎03-10-2016 11:11 AM
Date Last Visited	‎03-01-2024 12:02 AM
Posts	50
Total Helpful Votes Received	47

User Statistics

User Activity

Help with port config

Changing IP's on vlan1

Link lights just blinking on and off.

Connect 2 9500 switches - no stacking cable.

Help with translation pattern

Re: Help with port config

Re: Changing IP's on vlan1

Re: Changing IP's on vlan1

Re: Changing IP's on vlan1

Re: Changing IP's on vlan1