Hi,
i have a C8500L-8S4X with severeal ipsec L2L session. Several sessions use DH group 14, they should migrate to DH 21.
Are there any limitations to the crypto engine ? Have anyone a datasheet showing performance and throughput of the 8500L ?
I onl...
Hi,i have a ACI mini and everything works fine. After updating ACI to 4.2(7f), one of the virtual apics gets Unavailable after 4-5 days and gets only available again after Reboot. After Reboot, the vApic i available for another 4-5 days before gets u...
Hi, i have a setup with 1542AP's which i want to use to bridge two sites together. First Ap is ME and configured as RAP, the second as MAP ( Mesh ). Everything works fine, i can reach the AP over the Mesh link and i can reach a switch behind the MAP....
Hello,if i order a 9300 with network essentials, SWSS is included within all dna subscription.is it possible to download the newest IOS version within the SWSS ? SWSS is desribed as Software support, or do i need the SNTC for IOS updates ?thanks
Hello,
i want to use trustsec switch-to-switch link security in manual mode between a 3560CX and an IE5000
datasheet of IE5000: macsec is supported
configuration between two 3560cx is simple, only cts and key within the interface, and it works.
but t...
Hi,
since now, it is not fixed
but i heard from an expert, that the IE5000 use a different method for key exchange in macsec on uplink ports than on downlink ports, even if it's manual.
so manual macsec between two IE5000 on uplink should work, but n...
Hi Mario,
within the 3560CX-8TC-S i use the uplinks ( SFP or T ) for macsec, G0/9-12
the only case it never works for now is to connect the uplink ports of a IE-5000-16S12P via macsec to a 3560CX-8TC-S
I have opened a case, because it works on all...
Hi Mario,
sorry about the late response,
i use the lateste IOS version, but it works also with any other version on the 3560CX, only the IE5000 needs min. 15-2.5
you can use ports whatever you want, it works
Sorry about the late answer,
the customer has to plan an outage to test the new configuration, but still has no time to realize it. Now there is another issue.
The provider ASR can deliver a second connection to the customer 7K-VPC to get redunancy...
Hello,
attached the config of the Nexus, the vpc failure are because the 5K are yet only connected to the 7K1.
in addition: the ASR is physical connected to the 5K-1, but routed by the 7K-1
thanks
