DearsCan anyone help us simulate the values with the reports created by WAASWe received the following values from our provider, for a site they see83.82Gig received and 99.49Gig send, so total of 183.31gig over the linewhen we make a monthly report f...
HiLately we are getting a lot of excessive errors on ports where a AP is connectedsh int fa1/0/25 | i error|runt 669 runts, 0 giants, 0 throttles 669 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 output errors, 0 collisions, 0 inte...
Last my collegue asked me what is the default ACL when you put access-group on a interfacewhen looking on cisco.com I found :If the specified access list does not exist, all packets are passed.http://www.cisco.com/en/US/docs/ios/12_3/ipaddr/command/r...
we see sometimes on a 3750switchSW_MATM-4-MACFLAP_NOTIF: Host 000b.xxxx.xxxx in vlan 5 is flapping between port Gi2/0/42 and port Po7looking up the MAC we found wifi devices like a pc and handscanner which move to the building thereby changing from A...
can anybody help to enable load-balancing between different WAEs on a sitei added a drawing to this topicwe have 3 WAEs on the LAN and we would like to spread the load on all 3.At this moment this is not evenPlease helpthank you in advance
Hi can anyone confirm?A customer had bought ISE 1.2 with advanced licenses and got upgraded in the meantime and is now running 2.xcan anyone confirm that his advanced license of 2500 endpoints purchased in 1.2 got divided over 2500 plus en 2500 APex?...
Hi Zachthank you for the replybut the issue we have is that the values displayed by WAAS don't match with the edge router valuesfor some sites the WAAS has processed more traffic then that passed the router or the other way, which makes it difficult ...
Hey pkampanathx for this replyit was exactly what we were looking for but we couldn't test it our-self as we don't have an ASA box@kusankar thank you for your reply but pkampana provided the answer we were looking for
@ismail so enabling LAG didn't solve your problem?@eric so you suggest to check the roaming and make it to always use the same controller, setup like a primary - backup (wifi is not really my field in cisco :s )
Hi Jerry thank you for this clear explanationi would say this topic can be closed but i see others still have some questions so i wasn't alone with questions :)