About cisco4lct

cisco4lct · 04-10-2014

Hello, Our VoIP phones with PC connected trip port security because phone registers it's MAC in the Access VLAN before moving into the Voice VLAN.Please let us know the proper config to make this work and allow only 1 MAC in the Access VLAN!Cisco 37...

cisco4lct · 10-01-2013

We have NCM running on Redhat with mysql db. How do I reclaim some disk space? We're getting this error for devices that NCM is trying to snapshot: The table 'RN_DEVICE_ACCESS_LOG' is fullThe root partition is full:df -hFilesyst...

cisco4lct · 09-16-2010

Hi - I'm demo the NCM and trying to add devices using the Detect Network Devices feature to add many devices. It says success, but it marks the devices as Non Active Nodes and they don't show up anywhere in NCM (that I can see). When I use the add...

cisco4lct · 04-15-2014

I figured out the issue.The VoIP phones jump into the access VLAN just long enough to trip port security "IF" the VoIP MAC isn't already known by the interface config. However, once the VoIP MAC is part of the interface config, things work as expecte...

cisco4lct · 04-10-2014

We have this problem also. Does anyone have an answer?We're using cisco 3750x with IOS version 15.0(2)SE4 and Nortel 1120E VoIP phones.During startup the Phone with PC attached registers it's MAC in the access vlan before moving to voice vlan, thus ...

cisco4lct · 10-02-2013

Thank you for your reply Sir! After searching the drive, I found a 110GB audit_log.txt and just deleted it. Thanks for your suggestion and have a great day!

cisco4lct · 09-24-2010

Thanks JA! I'm using the Device Task "Import" with the provided device.csv template. All that seems necessary to import the devices is an IP address in the primaryIPAdress field, and it's working. Sounds like I don't need to set the SNMPv3 priv ...

cisco4lct · 09-24-2010

Thanks JA, I was able to figure out that the issue is SNMP authentication. So far I'm able to Detect Network Devices if I add an SNMPv1 community string with RW permissions to a switch. However, we are using SNMPv3 with aes encryption on our test. ...

Member Since	‎09-16-2010 04:15 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	10

User Statistics

User Activity

VOIP and port security with mac sticky not working as expected using max 1 vlan access

CiscoWorks NCM 1.5 server disk full: How do I reclaim space?

NCM Detect Network Devices fails, but New Device wizard works?

I figured out the issue.The

We have this problem also.

CiscoWorks NCM 1.5 server disk full: How do I reclaim space?

Re: NCM Detect Network Devices fails, but New Device wizard work

Re: NCM Detect Network Devices fails, but New Device wizard work