Hi,
For the past 3 months I have been experiencing a very strange issue on my Cisco catalyst 9300 and 3850 Switches. I logged in on many of the cisco switches and saw that a huge number of usernames and passwords are created ( I believe ) automatical...
Hello all,
I have setup a call center and used cucm 11.0 and ccx 11.0 and used 410 as my trigger short code.
When I call from GSM the call is seen in the voice gateway and dial peer is hit.
But I am not being played with the IVR I have configured in ...
Hello all,
Hope you are doing well. I have a question regarding cisco uccx 11.0, How can I add a script in the following script which can play message when the caller is put on hold.
Caller is answered by the agent and then agent puts the call on h...
When I do a "sh logging", on a cisco 3560 switch, I received the following message
"Invalid packet (too large) length=21584"
At the same time I had to experience heavy packet losses and cpu utilization was almost 99.9%.
The issue is still persist,...
I have a 2921 as a voice gateway. I have configured e1. When call comes from PSTN, I am getting the following message on the gateway
"
000243: Feb 20 17:04:24.090: ISDN Se0/0/0:15 Q931: RX <- SETUP pd = 8 callref = 0x000E
Sending Complete
...
Hi Pieterh,There is only 1 local user with a secret password and enable secret on the switch.ROM: IOS-XE ROMMONBOOTLDR: System Bootstrap, Version 16.8.1r [FC4], RELEASE SOFTWARE (P)I will disable the http and https secure and will monitor how it goes...
