Setup kron jobs to backup / redirect configs on specific days: sh run | s kronkron occurrence friday_backup at 22:30 Fri recurringpolicy-list friday_backup kron policy-list friday_backupcli show running-config | redirect tftp://192.168.XX.XXX/$h-$t_r...
I have been doing a bit of research on this and haven't found anything definitive on this but I feel it should work. Can anyone confirm or deny? Equipment:Virtual: ISE 2.4Cisco 3850 Stack(s) IOS 3.6.9E RADIUS Authentication works perfectly. Any assis...
I am working with a spare ASA 5512X. I had two modules installed previously, IPS and CXSC and the device worked (even though all modules were unresponsive). When I enter the command sw-module module ips recovery configure image flash:/<path> I get e...
What is the best way to stop and re-route traffic across OSPF enabled devices?
A server (SrvA) is connected a router (RtrA) running OSPF (Area 1) connected to a switch (SwA) which is connected via OSPF (Area0) to a different switch (SwB) running ...
It's running windows 10. I can tftp the config over to it manually. The job works for about a week then it dies out. I have a weeks worth of configs and then nothing. A few caveats, the destination is virtual but there is definitely a path as I can ...
I figured it was close to right, and I agree that by it showing inactive it is going to run on specified date / time. My confusion comes in that I don't have any backups to show on my tftp server.
Yeah after performing the shutdown command on the other modules it was able to uninstall successfully. I was messing with a spare and I just wanted to put it back the way I found it.
Thanks for shedding some light on that. On my 5512X I can connect to the sfr console, which I thought was the cli of the Firepower web gui. Is my only option to reinstall since I can't get into the Firepower web gui? I can see a basic status of the F...
