Dears, I have Cisco IOS-XE and want to see the output for the command (show policy-map interface) using Yang model to check the traffic byte for each class inside the policy .. so I used the model (Cisco-IOS-XE-policy). Still, i can't find the output...

Hi  all, I have NCS5508, when i check the command below sh controllers npu resources encap location 0/0/CPU0sh controllers npu resources encap location 0/1/CPU0 I found the below urrent Hardware UsageName: encapName: bank_0Estimated Max Entries : 409...

Hi , i have installed IOS XRv9000, and enabled BNG inside it ..  How i can add the number of subscriber session in PRTG ..is there any OID or MIB supported by XRv9000 Kind Regards  

Hi all , I'm working on XRv9k which already installed on hypervisor ESXI 6.5 , When i tried to config QinQ it's not work and can ad only one Vlan as a second second-dot1q .. How i can add range of VLAN in the second-dot1qinterface GigabitEthernet0/0/...