Hello, I want to monitor C6509 with DCNM as much is poosible. I can add device only with SNMP v1 read-write community. The SNMPV3 and SSH are also installed on the same device. But , when I start deep discovery the lan-client requred SNMP V3. How can...

Hello,I am using Cisco Works LMS 4.0 for collecting configurations of the devices. After changing the configuration of the device what is the minimum time that LMS detects the configuration was changed and save (make archive) the new configuration in...

Hello.During Sync archive for ASA-SSM-10 which is installed in ASA 5505 device I received the error:*** Device Details for Cisco ASA IPS ***Protocol ==> Unknown / Not ApplicableSelected Protocols with order ==> Telnet,SSHExecution Result:RUNNINGCM015...

Hello. When I change configuration for the ASA device with LMS 4.0 Configuration-->Tools-->Config Editor, the configuratin changed, but the job fails with the Error:Deploy command partially failed TELNET: Failed to establish TELNET connection to 172....

Hello. After succesfull adding SSM-10 IPS modul with primary credential (username/password) and SNMP V2 credentials (Both strings are correct)  to LMS 4.0, I am not able to succesfully finish the Device Credentials Verification Job and collecting the...