About lmiller

lmiller · 10-22-2012

I have just rebuilt our lms 4 server onto a newly built serve 2k8r2, from our old 2003 box.The software is installed, and setup, however I cannot get it to add any devices to the inventory. Every device it trys to talk to is classed as unreachable.I ...

lmiller · 03-16-2011

I am investigating LMS 4, and have it configured for device discovery - no issues there, but the configuration archive is not working with any of my Cisco 12xx AP's. I get the following error message.TELNET: Failed to establish TELNET connection to 1...

lmiller · 10-23-2012

Michael, Thanks for your help, but I dont have any devices in this new install of LMS4 to export, it wont add any of my devices at all.Using Getif 2.6.1 I can confirm that my SNMP communtiy strings are correct, but LMS wont seem to talk to the device...

lmiller · 10-23-2012

Totally new server with a fully fresh build.SNMP community has been checked on the device itselfsnmp-server community TSTECHW RWsnmp-server community TSTECHR ROsnmp-server community TSTECHRW RW SNMPWALK gives this:Cannot find module (IF-MIB): At line...

lmiller · 10-22-2012

Firewall is already off.

lmiller · 03-17-2011

I can telnet from the LMS host server without any issue. There is no firewall on the server, and there are no access lists, or VLAN filters on the switch ???

lmiller · 03-17-2011

OK - Getting there, on a 1240 AP the HTTP account is not the same as atelnet account.so by adding a local user account that is the same as the HTTP account we have some access.now need to look at the 3750 stack. The telnet and enable passwords are th...

Member Since	‎03-16-2011 04:09 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	8

User Statistics

User Activity

LMS 4 fresh Install on Server 2k8r2

Cisco LMS 4.0 & Cisco AP's

Re: LMS 4 fresh Install on Server 2k8r2

Re: LMS 4 fresh Install on Server 2k8r2

LMS 4 fresh Install on Server 2k8r2

Re: Cisco LMS 4.0 & Cisco AP's

Re: Cisco LMS 4.0 & Cisco AP's