Hi community,we have an issue with some NIC-cards connecting to a new standard switch device.Switch device is: WS-C4506-E sw. 12.2.53.SG1Modules:1 6 Sup 6L-E 10GE (X2), 1000BaseX (SFP) WS-X45-SUP6L-E2 48 10/100/1000Base...
Hi gentlemen,i have a CPE Router between provider and me.On this CPE Routers WAN Interface i have a high rate of output drops, even if the load is low.Is there a whitepaper available how to understand (output)-drops on interfaces?t...
Hi all,today my sw upgrade procedure failed on a ME3600 Series switch.**************************Interrupt within 5 seconds to abort boot process.Loading "flash:/update/me360x-universalk9-mz.151-2.EY/me360x-universalk9-mz.151-2.EY.bin"...@@@@@@@@@@@<....
Hi all,after a long time i have a new issue in our WAAS environment.We're running several WAAS Express devices.And a few weeks ago i integrated them into our WAAS Central Manager.The registration of WAAS Express device was done on basis of "waasx_dep...
Hi all,during last weekend i did sw upgrade (4.2.3c to 4.4.1) in my waas environment.after rebooting one of the devices there was one error occuring in the alarms:filesystem_size_mismatchntrwa001172.17.117.8 CriticalOne or more filesystems have got i...
Jepp cable is replaced, and at least devices were connected directly on the switch via different patch cords.Here the requested output:NXX#sh power inline module% Incomplete command.NXX#sh power inline module 2Available:3380(w) Used:139(w) Remaini...
I've opened a case at TAC, we verified also what'll happen when we auth via TACACS. But it doesn't matter. Still the same with local auth and remoe authentication via TACACS.
Hi Richard,thanks for checking.Your right, interface connectivity should be active.This is done meanwhile.I need to have a guide for setting IP settings via bootloader and than loading the IOS via TFTP.thanks for helpingDieter
