About Nils Magnus Eliassen

Nils Magnus Eliassen · 06-08-2016

Hi I'm configuring a VTI tunnel from a Cisco 881W to a Juniper SSG550. The tunnel will be terminate from a vrf named factorywl. To make the whole thing more exiting the Cisco will also be using DHCP to receive an IP address. Since the Cisco uses a DH...

Nils Magnus Eliassen · 10-19-2012

HiWe have a door that is opened using an analoge phone line (if you hit # on the other end it should open). The lock is connected to an ATA186.When the call is routed out of our CallManager and to the PSTN pressing the # in the other end works perfec...

Nils Magnus Eliassen · 07-16-2012

HiI'm finding it hard to create groups in AD and have the diffrent groups in AD assigned to diffrent roles in Cisco LMS 4.1Is it possible to have diffrent AD groups to assign the diffrent roles in LMS? If it's possible how should I do it so it work a...

Nils Magnus Eliassen · 08-09-2016

Hi I got it to work. I was able to do it before the vacation but I'm a little late publishing it here. The command that did the trick was "set aggressive-mode client-endpoint fqdn boat.example.com". I have written a bit more about the configuration I...

Nils Magnus Eliassen · 10-23-2012

Yes I can hear a tone while pressing # when I call another phone.

Nils Magnus Eliassen · 10-22-2012

I'm not in the office so I will try that tomorrow bruno_rangel. Both are at the same location.The ATA is using skinny as well and yes the ATA is hooked up with the door system

Nils Magnus Eliassen · 10-22-2012

HiI got nothing to do with the configuration of the door system so the only thing I know is that if I press # it should open. The door system is dialing a configured number when someone rings the doorbell, then it's a huntgroup and the first one to ...

Nils Magnus Eliassen · 07-17-2012

I found the following in the document: "The LMS Server determines user roles. Therefore, all users must be in the local database of user IDs and passwords. Users who are authenticated by an alternative service and who are not in the local database a...

Member Since	‎07-16-2012 05:51 AM
Date Last Visited	‎04-02-2018 09:05 AM
Posts	8

User Statistics

User Activity

VTI tunnel terminated in VRF not sending FQDN_ID

Problems with ATA186 and DTMF

Authinticating using groups from AD

Hi

Problems with ATA186 and DTMF

Problems with ATA186 and DTMF

Problems with ATA186 and DTMF

Authinticating using groups from AD