I have a terminal server that will not allow me to connect to devices configured on it. There are no other sessions or users on the terminal server at the time I am attempting to connect.Any ideas would be welcome.The configuraiton is attached, the e...

When attempting to ssh into the router the connection is never established..please see the following debug output:5494365: Jul 14 18:44:18.769 UTC: SSH0: starting SSH control process5494366: Jul 14 18:44:18.769 UTC: SSH0: sent protocol version id SSH...

I have an ACU2000 connected to an FXS port in a 3845 router. When an out going call is made the receiving phone rings, but when it is answered, it is reported on the originating phone that the caller is busy and call is disconnected. Any ideas?

I have a NEC PBX with the VoIP card in each PBX at each side of the WAN..the sites are connected via a T-1 with Cisco 2600s on each side. There is a tie line configured between the two PBXs, though the company responsible for this is very vague with ...

I am trying to get mutlilink PPP up between a cisco router (IOS 11.2) and a Nortel ARN...is there any interoperability issues (such as timers, etc) that need to be tweeked to get this running....or any other suggestions..