About irenof

irenof · 10-31-2025

Hi all,One of my clients wants to disable SNMP traps for access ports linkup and linkdown (F0532) events. I tried by "unselecting" Access Port (eqpt.LeafP) under SNMP tab of the monitoring policy is applied to the policy group of the leaf access por...

irenof · 09-01-2025

Hi all, I have the following situation:I want to create an L3out (SVI) and add a BGP peering. Since the SVI consists of both the 2 VPCs I add a new path to the Interface profile of the L3Out, with the same ip addressing scheme.My problem is how to cr...

irenof · 04-24-2025

Hi all,I am trying to configure 2 static bindings for two EGPs belonging to two different Tenant, but it does not work as expected.Here the recap of the situation:Tenant A -> EPG vl_100 -> Leaf 111 -> port eth1/5 -> vlan 100Tenant B -> EPG vl_100 -> ...

irenof · 04-10-2025

Hi all,wath does system-link-level-1G-auto do?I know that ACI put duplex always as full. But in this case, what will be the speed?I tried with a 1G connection that I have and I create a new LLP with Auto Neg On and Speed 100Mbps and I see that the Sp...

irenof · 03-28-2025

Hi all, next week I will migrate a FEX from legacy to ACI and so I have to configure Access and Tenant policies. For the Access policies is ok, I found many recources online and I am pretty confident the configuration is working. Unfortunatley I have...

irenof · 11-03-2025

Hi @balaji.bandi ,ACI version is 6.0(7).I followed the guide in the link to setup SNMP. But, then I was asked to remove access ports traps, but this does not work..

irenof · 09-18-2025

HI @MHM Cisco World, sorry for my late reply but I have been busy, too. I am still waiting for doing some test in a lab regarding all the stuff wrote in this thread. Did you read all? What do you think?thanks,Irenof

irenof · 09-02-2025

The test I performed does not use VPC, but only single interfaces. I just tested configuring a BGP peer profile under the interface that is not connetected to the router. I think that it should work also in VPC context, but at the moment it is no a t...

irenof · 09-02-2025

If the VPC where I "binded" the BPG peer goes down, what hapen to the session? I think that since there is the other VPC in the SVI, nothing happen. Even if the BGP peering is under the other VPC...I only tested this, with a SVI with two interfaces:...

irenof · 09-02-2025

Hi M02@rt37,I tried creating two equal BGP peers under both VPC paths (VPC10 enad VPC20):and ACI creates the same neigh conf twice under each leaf (i.e. two equal bgp neighs under leaf 101and two equal bgp neighs under leaf 102). The actual BGP sessi...

Member Since	‎09-23-2024 09:54 AM
Date Last Visited	‎11-13-2025 01:14 AM
Posts	58
Total Helpful Votes Received	13

User Statistics

User Activity

Disabling SNMP traps for access ports linkdown/linkup events

BGP peering over two VPC paths in L3out interface profile

How to configure same encap-VLAN in two different tenant on same Leaf

Link Level Policy 1G-auto ACI

Configure EPG static binding on a FEX port (maybe also with Ansible)

Re: Disabling SNMP traps for access ports linkdown/linkup events

Re: BGP peering over two VPC paths in L3out interface profile

Re: BGP peering over two VPC paths in L3out interface profile

Re: BGP peering over two VPC paths in L3out interface profile

Re: BGP peering over two VPC paths in L3out interface profile